wärmedämmende Bauprodukte

Motors for second escape route

12-volt drives or motors with emergency hand crank

Power supply to 12-volt electric motors in case of fire

Windows and French doors are often designated by fire safety planners as a secondary escape route within a building. However, it is essential to consider the type of shading and operating mechanism for these windows. If roller shutters with motorized drives are used, the shutters can quickly become a trap in the event of a power outage.

When equipped with our 12-volt drives or our emergency hand crank systems, the roller shutter curtains can be opened in fractions of a second using the low-voltage motor or the crank rod to clear the way out in emergency situations.

Self-explanatory, easy to assemble, simple to use, reliable, sustainable andOur solutions prove to be low-maintenance.

Produktbild 12 Volt Motor Rettungsweg

12 Volt Engine

Mechanical tubular motor 10 Nm, 17 rpm,
45 watts, 4 amps, IP44580 mm long, for SW 60,
for up to 2.8 sqm PVC roller shutters
with 2 m connection cable

Also available on request for SW 40 shaft and in larger designs.

Produktbild 12 Volt Schalter Kaiser-Niehaus

12 Volt Push Button

Timer switch for 12V DC motor with
Backup battery for emergency operation in case of power failure.
Withintegrated radio receiver and
Smoke detector signal evaluation for
automatic opening of the system in case of fire.

Functional reserve, even in the event of a power failure, thanks to integrated charging technology and battery.

Sun and twilight control via wireless sensor is possible. With an intermediate frame (50x50 mm according to DIN49075), this switch can be integrated into all standard switch ranges.
Crank rod in case of fire

Emergency hand crank (EHC) systems, in addition to our 12-volt drives, offer a quick way to open a second escape and rescue route in residential buildings, retirement homes or office buildings.

Often, in addition to stairwells and doors as the primary escape route, a second escape route is required. This is used if the first route is blocked, for example, by fire or smoke.

A window or balcony/patio door, often equipped with roller shutters, typically serves as a second escape and rescue route. However, this is not yet mandatory. The use of motorized roller shutters is not regulated by building codes.

According to the Federal Building Code, windows or French doors can serve as a second escape route; escape routes are described in the building code with a minimum height/width of 1,- 1.1 m.
Every building owner and proprietor should ensure that escape via the second escape route is possible in case of fire.

When using crank drives, we employ innovative solutions for attaching the crank rod to our roller shutter box. We prefabricate NHK systems within our roller shutter box, ensuring high-quality installation on site.

Motor fuer den 2.ten Rettungsweg

NHK tubular motor with crank rod

Automatic tubular motor 6 or 10 Nm or 20 Nm 17 rpm,150 watts, IP44for SW 60,
with Easy cable plug system.

Automatic detection of end positions in conjunction with rigid shaft connectors and stop blocks.
After activation with the NHK drive, the end positions remain unchanged.

With frost protection, obstacle detection, and parallel connection possible.

Its small dimensions allow for installation in confined spaces. Gear ratio 1:15.
Also available with a radio receiver.

Pre-assembled with special motor head for crank rod, suitable for all roller shutter boxes.

Roller shutter box with fan and drive for second escape route

If required, we also offer roller shutter wall boxes with integrated 12-volt motors or NHK systems, including a residential ventilation system.

Our roller shutter box system optionally offers a residential ventilation system with top-of-the-line features such as a heat recovery rate of up to 92%, an air flow rate of 50 m³ per hour, and high sound insulation of 59 dB.

Motor 12 Volt für Notausgang

Notes

Electric:

Electrical finishing work on this ventilation system may only be carried out by a qualified professional.The work must be carried out by a qualified electrician.

Ensure that the minimum requirements for the conductor cross-section are met.to avoid a voltage drop.When using multiple motors or ventilation units, these should be connected to their own separate safety device.(screw-in fuse, circuit breaker, etc.) can be connected.
Details can be found in the respective operating instructions.


Roller shutter slats:

A roller shutter box with a 12 volt motor / NHK system with crank rod has a roller space of 205 mm.
With a classic Berlin slat 52/14, a blind width of up to 2400 mm would be possible.
Higher roller shutter slats are available upon request.

Insect screen roller blinds can be used with our guide rail system.

Belt as an option for a second escape route

gedämmter Gurtausgang mit grüner Putzkappe
Gurt Raststück AKTIV-SYSTEM

Insulated belt exit with green cleaning cap

A strap allows for manual operation of the roller shutter curtain via the strap guide. To ensure that the strap guide is implemented with virtually no thermal bridges, we only offer our insulated strap exit.


After the cleaning work, the webbing is inserted. Here we offer

The matching locking piece with double brush seal is available. Discreet and each

Adjustable according to plaster thickness (adjustment range 0 - 20 mm).

gedämmter Mauerkasten - horizontal verstellbar - AKTIV-SYSTEM

Belt winder wall box

To ensure professional flush mounting of the webbing, we offer our thermally insulated wall box for the winder with a 45 mm horizontal adjustment range. This allows for optimal vertical installation of the webbing. (W x H x D) 119 x 247 x 238 mm - including plaster protection.


Mittellager - AKTIV-SYSTEM

CENTRAL BASE

Large window areas – wide window surfaces, two drives for one roller shutter curtain.


Also suitable for wave separation in large lift-and-slide door systems with e.g. seatbelt on the left and engine on the right.


The curtain needs to be divided and therefore requires

An intermediate/middle support. With our precisely fitting system and corresponding middle support, the division can be carried out quickly and safely. This is a boon for the roller shutter installer, as otherwise he would have to spend a lot of time installing stand bearings or...

would have to install something similar.



geprüftes und zugelassenes Rollladenkasten System